OnePortViewer

The OnePortViewer is a Windows application for viewing devices connected to only one COM port with multiple sub addresses having ASCII and ModbusRTU interfaces.
You can see the summarized weight re...

FourPortViewer

The FourPortViewer is a Windows application for viewing devices using the CANopen interface having one CANopen port and multiple addresses.
In ASCII and ModbusRTU mode you connect to individual CO...

DOP 4

The DOP 4 Windows application is a tool for calibration and tarring of the H&B load cell digital amplifier devices.

With the DOP 4 application, you can monitor weight values real time and do av...

H&B Display Single

The H&B Display Single is a Windows application for showing weight values on a single sizeable display panel and not having any other functionality than just showing weights.

The H&B Display S...

Ethernet IP Viewer

The Ethernet IP Viewer is a Windows application for setting up the DAD143 and EGM187 devices when to be configured to Ethernet/IP mode.
After the device is configured to Ethernet/IP mode, the data...

Profinet Viewer

The Profinet Viewer a Windows application for setting up the DAD143 and EGM187 devices when to be configured to Profinet mode.
After the device is configured to Profinet mode, the data flow can be ...

Modbus TCP Viewer

The Modbus TCP Viewer is a Windows application for setting up the DAD143 and EGM187 devices when to be configured to Modbus TCP mode.
After the device is configured to Modbus TCP mode, the data flo...

EtherCAT Viewer

The EtherCAT Viewer is a Windows application for setting up the DAD143 and EGM187 devices when to be configured to EtherCAT mode.
After the device is configured to EtherCAT mode, the data flow can...

LDx Programmer for new LDB / LDU Devices

Programs LDB151, LDB152, LDM64, LDU178, LDU179

H&B Programmer 3.x

General programmer for H&B Products.
You can program WCN122, CGM85, PGM86, EGM87, LDM88, LDU68, LDU69 and LDU78 with this version.

DAD 141.x Programming Tool

This tool is designed to upgrade the Firmware in DAD 141.x units.
note: Updating through Ethernet only works when the DAD141 has IPv4 Address 192.168.0.100.

Protocol Firmware Loader

Protocol Firmware Loader for DAD143 and EGM 187

LDU Download & Prog78

HBprogrammer v.2.4